Maintenance Menu Operations - Sony PDW-HD1550 Operation Manual

a) A "jumbo" frame is a frame larger than the maximum 1514 bytes (not
including FCS) of the standard Ethernet frame. Jumbo frames make it
possible to deliver larger payloads per packet. Since fewer packets need to
be routed, packet processing overhead is lower and network throughput is
potentially improved. (Note that this item is enabled only when LINK
SPEED is set to "1Gbps FullDuplex". For it to work, all other devices that
handle packets on the network must also support jumbo frames.)

Maintenance menu operations

This section describes the indications in the maintenance
menu and how to change the settings.
To display the maintenance menu
Holding down the PAGE/HOME button and the SHIFT
button, press the MENU button.
The maintenance menu appears on the video monitor
screen and the currently-set menu item is displayed in
reverse video.
Meanings of indications on the menu
screen
On-screen indication
Right-pointing arrow
(c) at the right of a
menu item
Left-pointing arrow (C)
at the left of a menu
item
Character string at the
right of a menu item
An * (asterisk) in a
complete list of settings
To change a menu item setting
Carry out the following operations to change the setting.
For information about how to change network settings, see
"To change network settings" (page 109).
108
Maintenance Menu
Meaning
Pressing the PUSH SET knob or
the b/OUT button switches to the
next lower menu level or to a
setting selection screen.
Pressing the PUSH SET knob or
the B/IN button switches to the
previous (higher) menu level.
Current setting of the menu item
When shown with a colon (:): the
current setting is the same as
the factory default setting.
When shown with a raised dot
(.): the current setting is
different from the factory
default setting.
Factory default setting
Function buttons (F1 to F6)
PAGE/HOME SHIFT button
button
1
Use the PUSH SET knob or the V/MARK1 and
v/MARK2 buttons to select the required item, then
press the PUSH SET knob or the SELECT function
button (F2).
The sub-items of the selected item appears.
2
Select a sub-item with the same operation as step 1,
and use the PUSH SET knob or the V/MARK1 and
v/MARK2 buttons to change the setting.
3
Press the PUSH SET knob or the SELECT function
button (F2) to confirm the setting change.
4
Press the SAVE function button (F5).
The message "NOW SAVING..." appears on the video
monitor screen, while the new settings are saved in
memory. When the saving operation is completed, the
video monitor screen returns to its normal indications.
To cancel changing a setting
Before pressing the SAVE function button (F5), press the
MENU button.
The menu disappears from the video monitor screen,
without saving the new setting.
MENU button
PUSH SET knob
Arrow buttons