Preparing Power Sources; Supplying Power; Attaching A Battery Pack; Ac Power Supply - Sony PDW-HR1 Operation Manual

Preparations

Preparing Power Sources

This unit can be powered by AC power, DC power, or a
battery pack.
For safety, use only the Sony battery packs listed below.
Lithium-ion battery pack: BP-L80S, BP-GL95
Note
If you load or remove a battery pack incorrectly, it may fall
and cause bodily injury. Follow the procedures described
below to load or remove them.

Supplying power

AC power supply

Connect the AC IN connector to an AC power source using
the specified AC power cord. To supply AC power to the
unit, set the on/standby switch on the control panel to =
(ON) and the POWER switch on the connector panel to =
(ON).

DC power supply

Connect the DC IN 12V connector to a DC power source.
To supply DC power to the unit, set the on/standby switch
on the control panel to = (ON) and the POWER switch on
the connector panel to OFF. If the POWER switch on the
connector panel is set to = (ON), AC power is supplied.

Battery power supply

Battery packs that can be used with this unit are as follows.
• BP-L80S
• BP-GL95
Continuous recording time at room temperature
BP-GL95 lithium-ion battery pack: 95 minutes
34
Preparing Power Sources
Chapter
For details on charging battery packs, refer to the
operation manual for the battery charger.
Notes about battery usage
• Before using the batteries, be sure to charge them fully
with the special battery charger. Refer to the operating
instructions for your battery charger for more
information about how to charge the batteries.
• Batteries may not be completely charged if you charge
them immediately after use when they are still warm.
You should wait until the batteries cool before charging
them.

Attaching a battery pack

Proceed as follows.
1
Remove the cover of the battery pack shoe.
2
1
2
Fit the battery pack.
3