Initial Setup - Sony PDW-HR1 Operation Manual

To remove the battery pack
Follow the above procedure in the reverse flow. After the
battery pack is removed, replace the cover of the battery
pack shoe.
Checking the remaining battery power
You can use the LEDs on the side panel of the battery to
check the remaining power of the battery.

Initial Setup

This unit is shipped with the area of use, system frequency,
recording format, and current date and time still unset.
Therefore, you need to make initial setup settings before
using the unit. (You cannot use the unit without setting it
up.)
Once the unit has been set up, the settings are retained even
when the unit is powered off.
Use the following procedures.
1
Power the unit on (see page 34).
The INITIAL SETUP screen appears on the display.
2
Turn the PUSH SET knob to select the area of use.
Display UC (for regions outside Japan) or J (for
Japan), and then press the SET function button (F5).
The system frequency screen appears.
3
Turn the PUSH SET knob to select the system
frequency.
35
Initial Setup