Input Signal Display; Data Indication; Monitor Channel; Audio Channel - Sony PDW-HR1 Operation Manual

2 Audio input display/Audio level meters
Displays information about audio. There are two display
modes for the audio level meter: FULL mode and FINE
Meter display mode: FULL

1 Input signal display

5 Audio channel

4 Monitor channel

3 AGC/limiter
a Input signal display
Displays the audio input signal.
.
Display Input signal
ANA-1 Analog audio
signal
ANA-2
ANA-3
ANA-4
MIC-1 Input signal from
the microphone
MIC-2
connected to
MIC-3 ANALOG AUDIO
INPUT connector
MIC-4
HD-SDI HDSDI audio signal (flashes when there is
no input signal)
SD-SDI SDSDI audio signal (flashes when there is
no input signal)
SG Test signal from the internal signal
generator
a) i.LINK TS (HDV) audio signal
iLINK
DVB-ASI TS audio signal
a)
DVB-ASI
No indication Undefined audio signal, or no audio input
a) When the PDBK-202 option board is installed

2 Data indication

8 Level bar
7 MIX indication

6 Reference level

Channel 1
Channel 2
Channel 3
Channel 4
Channel 1
Channel 2
Channel 3
Channel 4
mode, which can be switched over using AU METER on
page P2 AUDIO of the function menu.
Meter display mode: FINE
b Data indication
Appears when the input signals are non-audio signals.
c AGC/limiter
When analog signals are selected for audio input, displays
the AGC or limiter status.
AGC: An AGC value has been selected.
LIMIT: A limiter value has been selected.
d Monitor channel
Displays the audio monitoring channels set with the
AUDIO MONITOR SELECT buttons (see page 19).
e Audio channel
Displays the audio channels.
f Reference level
Displays the reference level for recording as set in the
maintenance menu.
1)
g MIX (mixing)
Appears when a channel has been specified as an output
destination. This indication appears when mixing has been
set up with item 843 AUDIO OUTPUT ARRANGE
the setup menu, and MIX/SWAP
of the function menu has been set to "ON".
9 Meter display mode
1)
in
1)
on the P2 AUDIO page
Display Panel
27