Function Menu Settings; P1 Video Page; Home Page - Sony PDW-HR1 Operation Manual

To clear the function menu from the screen
Basic operation display: Press the DISPLAY button to
switch to the video monitor display.
Video monitor display: After a menu operation, the menu
disappears after about four seconds.
To change the setting of a function menu
item
Use the function buttons.
To select the value of the setting item
Press the button to the left of each setting item to change
the value of the item. Keep pressing the button until the
value you want appears.
To set the value of the setting item
• Press the button to the left of each setting item so that the
setting value flashes to enable adjustment of the value
and then turn the PUSH SET knob to increase or
decrease the value.
• Turning the PUSH SET knob while holding down the
SHIFT button increases the increment of adjustment.
• Pressing the button to the left of each setting item while
the setting value is flashing causes the value to stop
flashing and completes the adjustment.

Function menu settings

The following tables list the setting items on each page and
describe their setting values. Underlined values are the
factory defaults.

HOME page

Item Setting
F1: CHAR SEL Turns the display of character
information on the color LCD and on an
external monitor on and off.
ON: Character information on
OFF: Character information off
LCD: Character information on for the
F2: PB/EE Selects the type of video and audio
signals to output during fast forward, fast
reverse, stop, and standby.
PB: Playback signal
EE: E-E signal
F3: REC INH Specifies whether to inhibit recording to
the disc.
OFF: Do not inhibit recording.
ON: Inhibit recording to the disc.
F4: CNTR SEL Selects the type of time data to display in
the time data display area.
TC: Timecode
UB: User bits
COUNTER: Elapsed recording or
50
Basic Function Menu Operations
color LCD only
playback time
Item Setting
F5: TCG SET • When CNTR SEL is set to "TC" ,
displays a screen where you can set
the initial value of the timecode
generated by the internal timecode
generator
• When CNTR SEL is set to "UB" ,
displays a screen where you can set
timecode user bits
F6: (Unassigned function button)
a) This is displayed only when the INT/EXT/SDI switch is set to "INT", and
the PRESET/REGEN switch is set to "PRESET".

P1 VIDEO page

Item Setting
F1: V INPUT Selects the video input signal.
HDSDI: HDSDI signal
SDSDI: SDSDI signal
CMPST: Composite signal
i.LINK: i.LINK signal (when the PDBK-
202 option board is installed)
DVB-ASI: DVB-ASI signal (when the
PDBK-202 option board is installed)
SG: Test signal from internal signal
generator
F2: LCD MODE Switches the video monitor display
mode.
Sub-Item
F1: SOURCE
F2: SDASPECT Aspect ratio of the
F3: COLOR
F4:
F5:
F6: EXIT
a)
(see page 45).
a)
(see page 45).
a)
Video output to display
on the video monitor
HD: Video output to
the HDSDI
OUTPUT 1 and 2
(SUPER)
b)
connectors
SD: Video output to
the SDSDI
OUTPUT
c)
connector
picture when "SD" is
selected
4:3
16:9
Color temperature of
the video monitor
HIGH: High color
temperature
LOW: Low color
temperature
–
–
Exits the video monitor
display mode sub
menu.