Maintenance Menu Operations - Sony PDW-HD1200 Operation Manual

Professional disc recorder
Hide thumbs Also See for PDW-HD1200:
Table of Contents

Advertisement

Item
M52: SUBNET MASK PRESET
M53: DEFAULT GATEWAY
PRESET
M54: LINK SPEED
M55: DUPLEX
a)
M56: JUMBO FRAME
M57: DNS1 PRESET
M58: DNS2 PRESET
M59: UPnP
M5F: RESET NET CONFIG
a) A jumbo frame is a frame larger than the maximum 1514 bytes (not
including FCS) of the standard Ethernet frame. Jumbo frames make it
possible to deliver larger payloads per packet. Since fewer packets need to
be routed, packet processing overhead is lower and network throughput is
potentially improved. (Note that this item is enabled only when LINK
SPEED is set to "1000Mbps". For it to work, all other devices that handle
packets on the network must also support jumbo frames.)
M5: NETWORK: Items relating to network settings
Setting
Set the subnet mask.
255.255.255.000
Notes
• Subnet mask cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired subnet mask, close the maintenance menu and then
open it again.
Set the address of the default gateway.
000.000.000.000
Notes
• The address of the default gateway cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of the default gateway, close the maintenance
menu and then open it again.
Set the communications speed.
AUTO, 10Mbps, 100Mbps, 1000Mbps
Set the communications method.
AUTO, Full Duplex, Half Duplex
For how to set the communication method, see "To change network settings" (page 140).
Set the size of jumbo frames.
9014, 4088, OFF (1514)
Note
This value does not include the 4 bytes of the FCS (Frame Check Sequence).
Set the address of DNS server 1.
000.000.000.000
Notes
• The address of DNS server 1 cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of DNS server 1, close the maintenance
menu and then open it again.
Set the address of DNS server 2.
000.000.000.000
Notes
• The address of DNS server 2 cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of DNS server 2, close the maintenance
menu and then open it again.
Select whether to enable the UPnP (universal plug and play) function.
DISABLE: Disable the UPnP function.
ENABLE: Enable the UPnP function.
Reset network settings to the factory defaults.
SAVE function button (F5): Reset.
MENU button: Return to the next highest menu level without executing the reset.

Maintenance menu operations

This section describes the indications in the maintenance
menu and how to change the settings.
To display the maintenance menu
Holding down the PAGE/HOME button and the SHIFT
button, press the MENU button.
139
Maintenance Menu

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents