Changing The Printer Driver Settings - Ricoh SP 3510SF User Manual

9. Troubleshooting
Problem
There is considerable delay between
the print start command and actual
printing.
Prints fall in front of the machine
when they are output.
Prints do not stack properly.
The whole printout is blurred.
The toner is powdery and comes
away from the paper, or the printed
image has a matt appearance.
Printed envelopes come out creased.

Changing the Printer Driver Settings

You may eliminate certain problems by changing the printer driver settings as described below.
386
• Processing time depends on data volume. High volume
data, such as graphics-heavy documents, take longer to
process.
• If "Processing..." is displayed on the screen, the machine
is receiving data. Wait for a while.
• To speed up printing, reduce the printing resolution using
the printer driver. For details, see the printer driver Help.
Raise the stop fence. See p.46 "Unpacking".
• Paper is damp. Use paper that has been stored properly.
See p.84 "Paper and Other Media".
• Raise the stop fence. See p.46 "Unpacking"
• Paper is damp. Use paper that has been stored properly.
See p.84 "Paper and Other Media".
• If you enable [Toner Saving] under [System Settings],
printing is generally less dense.
• Toner is almost depleted. If "Replacement Required: Print
Cartridge" appears on the screen, replace the print
cartridge.
• Condensation may have collected. If rapid change in
temperature or humidity occurs, use this machine only
after it has acclimatized.
Check if the levers for printing on envelopes inside the rear
cover are properly set. Pull up the levers.
Check if the levers for printing on envelopes inside the rear
cover are properly set. Lower the levers.
Solution