Configuring The Ipv6 Settings - Ricoh SP 3510SF User Manual

Item
Gateway

Configuring the IPv6 Settings

Click the [IPv6 Configuration] tab on the network settings page to configure the IPv6 settings.
IPv6
Item
IPv6
IPv6 Address
Item
DHCP
IP Address (DHCP)
Stateless Address
Gateway Address
Link-local Address
Enter the IPv4 address of the network gateway.
Select whether to enable or disable IPv6. You cannot disable IPv6 using
Web Image Monitor if the machine is currently in use in an IPv6
environment. In this case, use the control panel to disable [IPv6] under
network settings.
When disabled, [DHCP], [Manual Configuration Address], [Prefix Length],
and [Gateway Address] below cannot be configured.
Select whether or not the machine obtains its IPv6 address from a DHCP
server.
Displays the IPv6 address obtained from the DHCP server when [DHCP] is
set to [Active].
Displays up to four stateless auto addresses.
Displays the machine's default gateway address.
Displays the link local address of the machine. The link local address is an
address that is valid only inside the local network (local segment).
Configuring the Network Settings
Description
Description
Description
331