Ricoh SP 3510SF User Manual page 302

7. Configuring the Machine Using the Control Panel
Default: [PSTN]
• PSTN
• PBX
PBX Access Number
Specifies the dial number to access the outside line when the machine is connected to a PBX.
Make sure that this setting matches the setting of your PBX. Otherwise, you may not be able to send
faxes to outside destinations.
Default: 9
• 0 to 999
Function Priority
Specifies the mode that is activated when the power is turned on, or if the time specified for [System
Auto Reset Timer] elapses without activity while the initial screen of the current mode is displayed.
Default: [Copier]
• Copier
• Facsimile
• Scanner
System Auto Reset Timer
Sets the machine to return to the mode specified in [Function Priority].
Default: [On] (30 seconds)
• On (30 sec., 1 min., 2 min., 3 min., 5 min., 10 min.)
• Off
Energy Saver Mode
Sets the machine to enter Energy Saver mode, Energy Saver mode 1 or Energy Saver mode 2, to
reduce power consumption. The machine recovers from Energy Saver mode when it receives a
print job, prints a received fax, or when the [Copy] or [Start] key is pressed.
• EnergySaverMode 1
The machine enters Energy Saver mode 1 if the machine has been idle for about 30 seconds.
It takes less time to recover from Energy Saver mode 1 than from power-off state or Energy
Saver mode 2, but power consumption is higher in Energy Saver mode 1 than in Energy
Saver mode 2.
Default: [Off]
• Off
• On (30 seconds)
• EnergySaverMode 2
300