Changing The Printer Driver Settings - Ricoh SP C240SF Operating Instructions Manual

9. Troubleshooting
Problem
The whole printout is blurred.
The toner is powdery and comes
away from the paper, or the printed
image has a matt appearance.
9
Printed envelopes come out creased.

Changing the Printer Driver Settings

You may eliminate certain problems by changing the printer driver settings as described below.
Cannot print properly when using a certain
application, or cannot print image data
properly.
Some characters are printed faintly or not
printed.
372
• Paper is damp. Use paper that has been stored properly.
• Select [Lvl.1: Weak], [Lvl.2: Medium] or [Lvl.3: Strong] in
• If you enable [Toner Saving] under [System Settings],
• If you select [On] for [Economy Color] in the [Print
• Toner is almost depleted. If "Toner Almost Empty Replace
• Condensation may have collected. If rapid change in
Check if the fusing unit levers are properly set. Pull up the
fusing unit levers.
Check if the fusing unit levers are properly set. Lower the fusing
unit levers.
Possible Cause
Solution
See p.86 "Paper and Other Media".
[Anti-Humidity Level] under [System Settings]. Note that if
you select [Lvl.2: Medium] or [Lvl.3: Strong], the first print
takes longer than subsequent prints to complete.
printing is generally less dense.
Quality] tab (PCL/DDST printer driver) or under [Printer
Features] (PostScript 3 printer driver), print will be at
lower density. For details, see the printer driver Help.
Required Soon: Toner Cartridge (X)" ("X" indicates the
toner color) appears on the screen, replace the indicated
print cartridge.
temperature or humidity occurs, use this machine only
after it has acclimatized.
• Increase the print quality settings.
• Adjust the color density.
• Set the document to print in gray-scale.
• Increase the print quality settings.
• Set the document to print in gray-scale.
Solution