Specifying Paper Type And Paper Size - Ricoh SP 3510SF User Manual

6. Close the rear cover.
• After loading envelopes in the tray, specify the paper type and size using the control panel. Also,
specify the printer driver's paper setting accordingly before printing.
• Be sure to load envelopes so that their flaps are on the left. If you do not, the envelopes will
become creased.
• If printed envelopes come out badly creased, load the envelopes in the opposite direction, and
then rotate the print object by 180 degrees using the printer driver before printing. For details, see
the printer driver Help.
• For details about supported types of paper, see p.84 "Paper and Other Media".
• For details about specifying the paper type and size, see p.113 "Specifying Paper Type and
Paper Size".

Specifying Paper Type and Paper Size

This section describes how to specify the paper size and paper type using the control panel.
• Paper type and size can also be specified using the printer driver. For details, see the printer driver
Help.
• For prints from the bypass tray, you can select to print according to either the printer driver settings
or the control panel settings with [Bypass Tray Priority] under system settings.
• If [Auto Continue] under system settings is enabled, printing stops temporarily if a paper type/size
error is detected. The printing restarts automatically with the settings made with the control panel
after about ten seconds.
• For details about [Bypass Tray Priority], see p.279 "System Settings".
CMF076
Loading Paper
113