Loading Paper In Tray 2 - Ricoh SP 3510SF User Manual

• For details about paper types supported by the machine, see p.84 "Paper and Other Media".
• For details about the paper settings, see p.113 "Specifying Paper Type and Paper Size".

Loading Paper in Tray 2

The following example explains the loading procedure for tray 2.
• Before printing on paper other than envelopes, make sure to pull up the levers on the machine rear,
inside the rear cover. Leaving the levers lowered can cause print quality problems when printing on
paper other than envelopes.
• Make sure paper is not stacked above the limit mark inside the tray. Misfeeds might occur.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This machine does not detect the paper size automatically.
• Do not mix different types of paper in the same paper tray.
• Do not move the side paper guides forcefully. Doing so can damage the tray.
• Do not move the end paper guide forcefully. Doing so can damage the tray.
• When inserting the tray, make sure it is not slanted. Inserting it at a slant can damage the machine.
1. Pull out tray 2 carefully with both hands.
Place the tray on a flat surface.
CMF039
Loading Paper
105