Summary Of E1/T1 Ports Configuration Commands - Avaya G250 Administration Manual

Use the loopback remote command to request a remote station to activate or
●
deactivate a line or payload loopback signal on the controller interface. This command is
applicable only to a T1 line.

Summary of E1/T1 ports configuration commands

For more information about these commands, see Avaya G250 and Avaya G350 CLI
Reference, 03-300437.
Table 76: E1/T1 port configuration CLI commands
Root level
command
clear
controller
counters
controller
ds-mode
interface
serial
Command
cablelength long (T1)
cablelength short (T1)
channel-group
clock source
fdl
framing
linecode
loopback
loopback remote
Initial WAN configuration
Description
Reset the controller counters
Enter configuration mode for a specific
controller
Set transmit and receive levels for a cable
longer than 655 feet
Set transmit levels for a cable of length 655
feet or shorter
Create a channel group logical interface for a
PPP or Frame Relay session
Set the clock source for an E1 or T1
controller
Define the type of Facility Data Link
loopback that the remote line is requested to
enter
Set the frame type for an E1 or T1 data line
Set the type of line-code transmission for the
E1 or T1 line
Put a T1 or E1 line into loopback mode or
disable loopback mode
Reset the far end counters on a T1 line
Set the mode of the controller: e1 or t1
Enter Serial interface or sub interface
configuration context
Issue 5 June 2008
1 of 2
273