Usp Default Settings; Summary Of Usp Port Configuration Commands - Avaya G250 Administration Manual

Media gateways

Hide thumbs Also See for G250:

Table of Contents

Configuring WAN interfaces

USP default settings

Table 77: USP default settings

Line-up indicator signal

For more information about these commands, see Avaya G250 and Avaya G350 CLI

Reference, 03-300437.

Table 78: USP port configuration CLI commands

Root level command

interface serial

276 Administration for the Avaya G250 and Avaya G350 Media Gateways

idle-character

invert txclock

nrzi-encoding

transmitter-delay

Default setting

Enter Serial interface or sub interface

configuration context

Set the bandwidth parameter manually for

this interface

Set the bit pattern used to indicate an idle

Specify how the system monitors the line

to determine if it is up or down

Invert the transmit clock signal from the

data communications equipment (DCE)

Configure the IP address and subnet

mask of the interface

Enable or disable the non-return-to-zero

inverted (NRZI) line coding format on the

Set the minimum number of flags to be

sent between successive packets