Changing Radius Parameters; Disabling Radius Authentication; Displaying Radius Parameters - Avaya G250 Administration Manual

Accessing the Avaya G250/G350 Media Gateway
2. Use the set radius authentication secret command to set the shared secret for
the authentication. This command must be followed by a text string. For example:
set radius authentication secret hush
3. Use the set radius authentication server command to set the IP address of the
primary or secondary RADIUS Authentication server.
For more information about these commands, see Avaya G250 and Avaya G350 CLI
Reference, 03-300437.

Changing RADIUS parameters

The following commands are optional:
Use the set radius authentication retry-number command to set the number
●
of times to resend an access request when there is no response.
Use the set radius authentication retry-time command to set the time to wait
●
before resending an access request.
Use the set radius authentication udp-port command to set the RFC 2138
●
approved UDP port number. Normally, the UDP port number should be set to its default
value of 1812. Some early implementations of the RADIUS server used port number 1645.

Disabling RADIUS authentication

Enter set radius authentication disable to disable RADIUS authentication on the
G250/G350.

Displaying RADIUS parameters

Enter show radius authentication. Shared secrets are not displayed.
64 Administration for the Avaya G250 and Avaya G350 Media Gateways