Summary Of Mss Configuration Cli Commands - Avaya G250 Administration Manual

Accessing the Avaya G250/G350 Media Gateway

Summary of MSS configuration CLI commands

For more information about these commands, see Avaya G250 and Avaya G350 CLI
Reference, 03-300437.
Table 15: MSS configuration CLI commands
Command
composite-operation
destination-ip
dos-classification
ip access-control-list
ip-rule
ip-protocol
set mss-notification rate
show mss-notification rate
show snmp
snmp-server
dynamic-trap-manager
snmp-server group
snmp-server host
snmp-server user
88 Administration for the Avaya G250 and Avaya G350 Media Gateways
Description
Edit the specified composite operation. If the composite
operation does not exist, it is created
Specify the destination IP address of packets to which
the current rule applies
Set a label for a user-defined DoS attack classification
to be reported in MSS notifications
Enter configuration mode for the specified policy access
control list. If the specified list does not exist, the
system creates it and enters its configuration mode.
Enter configuration mode for the specified rule. If the
specified rule does not exist, the system creates it and
enters its configuration mode.
Specify that the current rule applies to packets having
the specified IP protocol
Set the rate at which the gateway sends Managed
Security Services (MSS) notifications
Show the interval time, in seconds, between MSS
notifications
Display SNMP configuration information
Modify the SNMP settings of the dynamic trap manager
Define a new SNMPv3 group, or configure settings for
the group
Identify an SNMP management server, and specify the
kind of messages it receives
Configure settings for an SNMPv3 user