3. Insert the USB mass storage device into the PC's USB port, and copy the firmware file(s)
to the USB mass storage device as follows:
a. Copy G250 or G350 firmware files to the root directory.
b. Copy the G350 Device Manager firmware file to the root directory.
c. Copy media modules' firmware files to the MM subdirectory.
d. Copy IP phone firmware files to the IPPHONE subdirectory.
4. Remove the USB mass storage device from the PC, and insert it in the G250/G350 USB
port.
5. Enter restore usb usbdevice0 backup-name, where backup-name is the root
directory path and name on the USB mass storage device.
6. Enter show restore status to check the status of the restore operation. The report
lists the upgraded files.
Uploading software and firmware from the gateway
Copying files to a USB mass storage device
You can use a USB mass storage device inserted into the G250/G350 USB port to copy
individual files to a USB mass storage device.
Use the copy file usb command to upload a specific file from the gateway to the USB mass
storage device, where file can be any of the following:
announcement-file. Announcements files
●
auth-file. Authentication file
●
phone-scriptA. Phone script bank A in the gateway's TFTP directory
●
phone-scriptB. Phone script bank B in the gateway's TFTP directory
●
license-file. The VPN license file
●
startup-config. The startup configuration file
●
capture-file. The packet sniffing buffer
●
dhcp-binding. The DHCP binding file
●
syslog-file. The syslog file
●
cdr-file. A Call Detail Recording (CDR) file
●
Copying files to an FTP/SCP/TFTP server
Use the copy file ftp command to upload a specific file from the gateway to an FTP
●
server, where file can be any of the following:
announcement-file. Announcements files
●
auth-file. Authentication file
●
Software and firmware management
Issue 5 June 2008
113