Replacing The Asg Authentication File - Avaya G250 Administration Manual

full path and ip is the IP address of the host. The gateway prompts you for a
username and password after you enter the command.
To download an authentication file from a remote SCP server: copy scp auth-file
●
filename ip, where filename is the name of the authentication file, including the
full path and ip is the IP address of the host. The gateway prompts you for a
username and password after you enter the command.
To download an authentication file from a remote TFTP server: copy tftp
●
auth-file filename ip, where filename is the name of the authentication file,
including the full path and ip is the IP address of the host. The gateway prompts you
for a username and password after you enter the command.
The authentication file is downloaded. You can view the download status using show
download auth-file status.
Note:
By default, Avaya Services login access is enabled as soon as the authentication
Note:
file is downloaded to the gateway. If Avaya Services login access was blocked
using no login authentication services-logins, you can reactivate is
using login authentication services-logins.
3. For connection to Avaya Services via modem dial-up, enable the RASaccess operation
mode for modem operation, using ppp authentication ras. The gateway must also
be configured for remote modem access and enabled, as described in Installing and
Upgrading the Avaya G250 Media Gateway, 03-300434 or Installing and Upgrading the
Avaya G350 Media Gateway, 03-300394.
4. For connection to Avaya Services via embedded VPN service, set up the VPN service for
Services to connect.

Replacing the ASG authentication file

In case of any problems with the ASG authentication file, you can download a newer
authentication file from the Authentication File System (AFS). You cannot install an
authentication file with a different authentication file ID to that of the authentication file currently
installed in the gateway.
Note:
If there is a need to install an authentication file with a different ID, you must first
Note:
delete the current authentication file using the command erase auth-file.
This command requires Supervisor level access and can only be used when
directly connecting to the Console or Services port. If you do delete the
authentication file and replace it with an authentication file with a new ID, the
authentication file label on the gateway chassis must also be replaced.
Managing login permissions
Issue 5 June 2008 55