Basic device configuration
Viewing the status of the device
To view the status of the Avaya G250/G350 Media Gateway, use the following commands:For
more information about these commands, see Avaya G250 and Avaya G350 CLI Reference,
03-300437.
Enter show faults to view information about currently active faults.
●
Use the show image version command to display the software version of the image on
●
both memory banks of the device.
Enter show mgc to view information about the Media Gateway Controller with which the
●
G250/G350 is registered. For more information, see
Controller (MGC)
Use the show mm command to view information about media modules that are installed on
●
the G250/G350. To view information about a specific media module, include the slot
number of the media module as an argument. For example, to view information about the
media module in slot 2, enter show mm v2. The output of the command shows the
following information:
- Slot number
- Uptime
- Type of media module
- Description
- Serial number and other hardware identification numbers
- Firmware version
- Number of ports
- Fault messages
Use the show module command or enter show mg list_config to view brief
●
information about media modules that are installed in the G250/G350. To view brief
information about a specific media module, include the slot number of the media module
as an argument. For example, to view information about the media module in slot 2, enter
show module v2. The output of the command shows the following information:
- Slot number
- Firmware version
- Type of media module
- Media module code
Enter show system to display the serial number of the G250/G350, the G250/G350's
●
uptime, the firmware version number, MAC addresses, and other system information.
Enter show restart-log to view information about the last time the G250/G350 was
●
reset.
106 Administration for the Avaya G250 and Avaya G350 Media Gateways
on page 92.
Configuring the Media Gateway