Summary Of Pmi Configuration Cli Commands - Avaya G250 Administration Manual

Configured PMI. The PMI that the G250/G350 is configured to use after reset, as
●
defined in the startup configuration file
If you use this command after you reset the G250/G350, both the Active and the
Configured PMI should be the same IP address.
7. Use the following commands to configure other identification information:
Use the set system contact command to set the contact information for the
●
G250/G350
Use the set system location command to set the location information for the
●
G250/G350
Use the set system name command to specify the name of the G250/G350
●

Summary of PMI configuration CLI commands

For more information about these commands, see Avaya G250 and Avaya G350 CLI
Reference, 03-300437.
Table 16: PMI configuration CLI commands
Root level
command
interface
(fastethernet|
serial|tunnel|
vlan|loopback|
dialer)
set system
contact
set system
location
set system
name
show pmi
Command
pmi
Configuring the Primary Management Interface (PMI)
Description
Enter configuration mode for the
FastEthernet, Serial, Tunnel,
VLAN, Loopback, or Dialer
interface
Set the current interface as the
Primary Management Interface
for the system
Set the contact information for
this media gateway system
Set the location information for
this media gateway system
Set the name of the media
gateway system
Display the current Primary
Management Interface
Issue 5 June 2008 91