Viewing The Status Of The Device - Avaya G250 Administration

Viewing the status of the device

To view the status of the Avaya G250/G350 Media Gateway, use the following commands. For
more information about these commands, see Avaya G250 and Avaya G350 CLI Reference,
03-300437.
Use the show faults command to view information about currently active faults.
●
Use the show mgc command to view information about the Media Gateway Controller with
●
which the G250/G350 is registered. For more information, see
Gateway Controller (MGC)
Use the show mm command to view information about media modules that are installed on
●
the G250/G350. To view information about a specific media module, include the slot
number of the media module as an argument. For example, to view information about the
media module in slot 2, enter show mm v2. The output of the command shows the
following information:
- Slot number
- Uptime
- Type of media module
- Description
- Serial number and other hardware identification numbers
- Firmware version
- Number of ports
- Fault messages
Use the show module command or the show mg list command to view brief
●
information about media modules that are installed in the G250/G350. To view brief
information about a specific media module, include the slot number of the media module
as an argument. For example, to view information about the media module in slot 2, enter
show module v2. The output of the command shows the following information:
- Slot number
- Firmware version
- Type of media module
- Media module code
Use the show system command to display the serial number of the G250/G350, the
●
G250/G350's uptime, the firmware version number, MAC addresses, and other system
information.
Use the show restart-log command to view information about the last time that the
●
G250/G350 was reset.
on page 59.
Viewing the status of the device
Configuring the Media
Issue 1.1 June 2005 71