Basic device configuration
Viewing the status of the device
Accessing the registered MGC
To access the G350's registered MGC through the G350:
•
If the MGC is an S8300 media server, use the
•
If the MGC is an S8500 or S8700 media server, use the
define the MGC's IP address, then use the
If the G350 includes an S8300, use the
command whether or not the local S8300 is the G350's registered MGC.
NOTE:
Both the
to the MGC.
To open a connection directly to the Avaya Communication Manager System Access Terminal (SAT)
application in the MGC, add
G350-001> session mgc sat
To open a connection to the MGC's LINUX operating system, do not add
example:
G350-001> session mgc
Monitoring the ICC or LSP
When an MGC controls telephone services on the Avaya G350 Media Gateway in ICC or LSP mode, the
G350 monitors the connection with the MGC. If the connection with the MGC is lost, the G350 starts a
recovery process. Use the following commands to configure MGC monitoring:
•
Use the
enable
monitoring.
•
Use the
Viewing the status of the device
To view the status of the Avaya G350 Media Gateway, use the following commands. For more
information about these commands, see Avaya G350 Media Gateway CLI Reference, 555-245-202.
•
Use the
•
Use the
which the G350 is registered. For more information, see
Controller (MGC)
44
session icc
session mgc
command and the
to the command. For example:
sat
command to control heartbeat monitoring of an ICC or LSP. The
set icc-monitoring
parameter enables heartbeat monitoring. The
command to display the status of the ICC/LSP monitoring process.
show icc-monitoring
command to view information about currently active faults.
show faults
command to view information about the Media Gateway Controller with
show mgc
on page 41.
command
session mgc
set mediaserver
command to access the MGC
session mgc
command to access the S8300. You can use this
session icc
command open a telnet connection
parameter disables heartbeat
disable
Configuring the Media Gateway
Administration of the Avaya G350 Media Gateway
command to manually
to the command. For
sat
June 2004