Table of Contents
Advertisement
Figure 166
VIDEO SETUP page
Note
Without support for video
(MCA), this page will display
the NO VIDEO button.
Note
The Color Video mini-touch
panel does not support non-
interlaced video sources, this
applies to both NTSC and
PAL video formats.
96
Touch Panel Program Reference
VIDEO SETUP
so you can set the incoming video display on the mini-touch panel.
Use the Video Setup page to set the incoming video display on the color video mini-
touch panel.
BRIGHTNESS
Press UP or DN to increase or decrease the brightness level of
the input video. The brightness range is from 0–255. You can also press SET TO
DEFAULT to automatically set the bright level to 128 (factory setting).
CONTRAST
Press the UP button to increase or DN button to decrease the
contrast of the input video. The contrast range is from 0–255. Press SET TO
DEFAULT to automatically set the contrast level to 128 (factory setting).
SET TO DEFAULT
AUTO/MANUAL SELECT
for the video circuitry to auto-detect the standard.
NTSC LOCKED /SECAM / PAL LOCKED
video (NTSC, SECAM, or PAL) is being supplied to the panel. If AUTO
SELECT is enabled, the touch panel automatically detects and locks in on the
signal type, and displays the video type in the button. If MANUAL SELECT is
enabled, you can manually set the composite video type with this button.
VIDEO X.XX
Shows the video firmware version of the mini-touch panel.
Sets the button to open the Video Setup page (Figure 166)
Resets the Video Setup page to factory default settings.
Allows you to manually set the video standard or
Shows which type of composite
Color Active-Matrix LCD Mini-Touch Panels
Advertisement
Table of Contents
