AMX Color Active-Matrix LCD Instruction Manual page 101

Figure 161
BUTTON TYPE menus
Color Active-Matrix LCD Mini-Touch Panels
GENERAL
Sets the button to automatically send a message to the Central
Controller via the AXlink connector, PC via the RS-232 connector, or with
WAVE wireless communication. Refer to Properties Page — Button Types:
General button this subsection for more information.
JOYSTICK
Sets the button to a joystick that includes a control stick. When
you move the control stick, the touch panel sends feedback (data) to the Cen-
tral Controller and to the external device to perform a pre-programmed op-
eration. Refer to Properties Page — Button Types: Joystick button this subsection
for more information.
VERTICAL BARGRAPH
Feedback for bargraph or slider response comes from the Central Controller.
Refer to Properties Page — Button Types: Vertical bargraph button this sub-
section for detailed information.
HORIZONTAL BARGRAPH
slider. Feedback for bargraph or slider response comes from the Central Con-
troller. Refer to Properties Page — Button Types: Horizontal bargraph button this
subsection for detailed information.
BRIGHTNESS
Sets the button to open the Brightness page shown in
Figure 162. The Brightness page allows you to set the touch panel's LCD
light level. The minimum brightness setting is 1 and maximum is 8. Refer to
the Set brightness subsection for detailed information.
Sets the button to a vertical bargraph or slider.
Sets the button to a horizontal bargraph or
Touch Panel Program Reference 93