AMX Color Active-Matrix LCD Instruction Manual page 21

Figure 13
AXD-MCV/PB and BB-MTP
UniMount Back Box (plaster-
board)
Note
The touch panel must always
be installed with the release
slot located at the bottom.
Color Active-Matrix LCD Mini-Touch Panels
Stud
mounting
holes
2.
Carefully insert a flat-blade screwdriver into the release slot on the touch panel's
faceplate and remove the engraved overlay.
3.
Lay the touch panel facedown onto a soft cloth and remove the screws from the
low-profile Back Box. Remove the Back Box and discard.
4.
Place the BB-MTP into the cutout and mark the threaded insert positions as
shown for the UniMount (Figure 14) or the Decor-style panel (Figure 15).
5.
Remove the BB-MTP and drill four #6-32 insert holes. Then, place a threaded in-
sert (or screw anchor) into each hole.
6.
Remove the BB-MTP and drill four #6-32 insert holes. Then, place a threaded in-
sert (or screw anchor) into each hole.
7.
Disconnect the AXlink connector from the Central Controller and optional video
wiring from the video source.
BB-MTP UniMount Back
Box enclosure
Plasterboard surface
mounting flanges
Knockout
Expansion clips
AXD-MCV/PB
faceplate
Engraved overlay
Installing Mini-Touch Panels 13