Double Beep; Axlink, Output Resolution, Vx.xx, And Serial Number; Set Brightness - AMX Color Active-Matrix LCD Instruction Manual

Figure 97
DOUBLE BEEP button
Note
You can set the beep value
setting using the 'ABEEP' and
'ADBEEP' Send_ Commands
described in the AXCESS
Programming section. The
'QBEEP' command is used for
overriding.
Figure 98
AXlink, OUT RES, vX.XX,
and SERIAL # button exam-
ples
64 Touch Panel Program Reference
DAY
Press the UP and DN buttons to set the day.
SECOND
Press the UP and DN buttons to set the seconds.
DISPLAY MONTH/DAY, DAY/MONTH
and day display.
DISPLAY 12:00/24:00
format. For example, the 12-hour clock format changes from 12:00 to 1:00,
and the 24-hour clock changes from 12:00 to 13:00.

Double beep

Press the DOUBLE BEEP button (Figure 97) to toggle the double beep ON or OFF.
The double beep sounds each time you press the screen.
Set the BEEP button (described earlier) to 0 to disable the double-beep sound.

AXlink, output resolution, vX.XX, and serial number

The AXlink, OUTPUT RESOLUTION, vX.XX, and SERIAL # buttons shown in
Figure 98 are information buttons (display only).
The AXlink button is an AXCESS communication indicator that blinks once every
second when the Central Controller is connected to the touch panel. The OUTPUT
RESOLUTION button shows the screen resolution. The vX.XX button shows the cur-
rent firmware version installed in the touch panel. The SERIAL # button shows the
serial number for the touch panel.

Set brightness

Press SET BRIGHTNESS in the SETUP page to open the page shown in Figure 99.
Press to set the order of the month
Press to set the clock display to a 12- or 24-hour
Color Active-Matrix LCD Mini-Touch Panels