AMX Color Active-Matrix LCD Instruction Manual page 14

Figure 5
AXU-MCA (/PB) and low-pro-
file Back Box
Note
The touch panel must always
be installed with the release
slot located at the bottom.
Note
The front cover of a UniMount
touch panel is called the
backing plate. The front cover
of a Decor-style touch panel
is called the faceplate.
6 Installing Mini-Touch Panels
1.
For UniMount–style (AXU) touch panels, cut out the surface using the dimen-
sions shown in Figure 6. For Decor-style (AXD) touch panels, cut out the surface
using the dimensions shown in Figure 7.
2.
Carefully insert a flat-blade screwdriver into the release slot on the touch panel's
faceplate and remove the engraved overlay.
3.
Place the touch panel into the cutout and mark the screw insert positions as
shown for the UniMount (Figure 6) or the Decor-style panel (Figure 7).
4.
Remove the touch panel and drill four #6-32 insert holes. Then, place a threaded
insert into each hole.
5.
Disconnect the AXlink connector from the Central Controller.
6.
Thread the incoming AXlink and optional RCA video connectors through the
low-profile Back Box.
Low profile Back Box
AXU-MCA bezel
Engraved overlay
Release slot
Color Active-Matrix LCD Mini-Touch Panels