AMX Color Active-Matrix LCD Instruction Manual page 22

Figure 14
UniMount (AXU) and BB-MTP
cutout dimensions for plaster-
board
Note
Refer Wiring the Mini-Touch
Panel subsection for pinout
descriptions.
14 Installing Mini-Touch Panels
8.
Remove the BB-MTP and drill four #6-32 insert holes. Then, place a threaded in-
sert (or screw anchor) into each hole.
9.
Disconnect the AXlink connector from the Central Controller and optional video
wiring from the video source.
10.
Remove one or more knockouts to accommodate the wiring as required.
11.
Thread the incoming AXlink and optional video wiring through the BB-MTP
knockout.
Color Active-Matrix LCD Mini-Touch Panels