Quick Steps For Network Administrator User Accounts - Alcatel-Lucent OmniSwitch AOS Release 6 Manual

Overview of User Accounts

Quick Steps for Network Administrator User Accounts

1
Configure the user with the relevant username and password. For example, to create a user called
thomas with a password of techpubs, enter the following:
-> user thomas password techpubs
For information about creating a user and setting up a password, see
2
Configure the user privileges (and SNMP access) if the user should have privileges that are different
than those set up for the default user account. For example:
-> user thomas read-write domain-network ip-helper telnet
For information about the default user settings, see the next section. For information about setting up privi-
leges, see "Configuring Privileges for a User" on page
Note. Optional. To verify the user account, enter the
following:
User name = admin
Read Only for domains
Read/Write for domains
Snmp not allowed
User name = public
Read Only for domains
Read/Write for domains
Snmp authentication
User name = thomas
Read Only for domains
Read/Write for domains
Read/Write for families
Snmp not alloweds
User name = default
Read Only for domains
Read/Write for domains
Snmp not allowed
For more information about the show user command, see the OmniSwitch CLI Reference Guide.
page 10-6
10-17.
show user command. The display is similar to the
= None,
= All ,
= None,
= All ,
= NONE, Snmp encryption = NONE
= None,
= Network ,
= telnet ip-helper ,
= None,
= None,
OmniSwitch AOS Release 6 Switch Management Guide
Managing Switch User Accounts
"Creating a User" on page 10-10.
July 2010