Alcatel-Lucent OmniSwitch AOS Release 6 Manual page 132

SNMP Overview
No. Trap Name
150 alaMvrpVlanLimitReachedEvent
alaMvrpMaxVlanLimit—The the maximum number of dynamic VLANs that can be created on the system by
MVRP. If the number of VLANs created by MVRP reaches this limit, the system will prevent MVRP from cre-
ating additional VLANs (32 - 4094, Default = 256).
151 alaMvrpE2eVlanConflict
alaMvrpVlanConflictInfo—The Port and VLAN on which the MVRP PDU was recieved.
152 alaDhcpSrvLeaseUtilizationThreshold alaDhcpSrv-
alaDhcpSrvLeaseThresholdStatus—The threshold status of subnet utilization.
alaDhcpSrvSubnetDescriptor—The subnet Descriptor. If the subnet belongs to a shared network, this object
specifies the shared network name; otherwise, it specifies the Subnet IP.
153 Reserved1
154 Reserved2
155 Reserved3
156 Reserved4
157 alaDhcpClientAddressAddTrap
alaDhcpClientAddress—The current IP address of the DHCP client.
158 alaDhcpClientAddressExpiryTrap
alaDhcpClientAddress—The current IP address of the DHCP client.
159 alaDhcpClientAddressModifyTrap
alaDhcpClientAddress—The current IP address of the DHCP client.
ala DhcpClientNew Address—The new IP address assigned for the DHCP client.
page 3-46
Objects Family
alaMvrpMaxV- mvrp
lanLimit
alaMvrpVlan- mvrp
ConflictInfo
dchpsrv
LeaseThresh-
oldStatus,
alaDhcpSrv-
SubnetDe-
scriptor
NA NA
NA NA
NA NA
NA NA
alaDhcpClient udp relay
Address
alaDhcpClient udp relay
Address
alaDhcpClient udp relay
Address,
ala Dhcp
ClientNew
Address
OmniSwitch AOS Release 6 Switch Management Guide
Using SNMP
Description
This trap is sent when the num-
ber of VLANs learned dynami-
cally by MVRP reaches the
configured limit.
This trap is sent when MVRP
receives a registration for a
VLAN that is configured for End
To End Flow Control.
This trap is sent when the lease
utilization on a subnet exceeds or
falls below the configured
threshold value.
This trap is sent when a new IP
address is assigned to DHCP Cli-
ent interface.
This trap is sent when the lease
time expires or when the DHCP
client is not able to renew/rebind
an IP address.
This trap is sent when the DHCP
client is unable to obtain the
existing IP address and a new IP
address is assigned to the DHCP
client.
July 2010