Alcatel-Lucent OmniSwitch AOS Release 6 Manual page 72

Using FTP
You have to enter a valid user name and password for the host you specified with the
which you will get a screen similar to the following display:
Name:Jsmith
331 Password required for Jsmith
Password: *****
230 User Jsmith logged in.
Note It is mandatory to specify the name of the particular IPv6 interface, if the target has been specified
.
using the link-local address.
After logging in, you will receive the ftp-> prompt, where you can execute the FTP commands that are
supported on the switch. For further information refer to the OmniSwitch CLI Reference Guide.
Note You must use the binary mode (bin) to transfer image files via FTP.
.
page 2-10 OmniSwitch AOS Release 6 Switch Management Guide
Logging Into the Switch
ftp6 command, after
July 2010