Alcatel-Lucent OmniSwitch AOS Release 6 Manual page 181

Managing CMM Directory Content
To save the running configuration to the working directory, enter the
prompt, as shown:
-> copy running-config working
or
-> write memory
The above commands perform the same function. When these commands are issued the running configu-
ration with all modifications made is saved to a file called boot.cfg in the working directory.
Note. This command will not function if the switch is running from the certified directory. See
the Switch Running From?" on page 5-5
The write memory command are described in detail in the OmniSwitch CLI Reference Guide.
Note. The saved boot.cfg file will be overwritten if the
write memory command in an OmniSwitch set up with redundant CMMs.
Note. It is important to certify the working directory and synchronize the stack as soon as the validity of
the working directory software is established in OmniSwitch 6400, 6800, and 6850 switches only. Stacks
booted from the working directory or unsynchronized stacks are at risk of mismanaging data traffic due to
incompatibilities in different versions of switch software. Certifying the working directory is described in
"Copying the Working Directory to the Certified Directory" on page
is described in "Synchronizing the Primary and Secondary CMMs" on page
OmniSwitch AOS Release 6 Switch Management Guide
Managing the Directory Structure (Non-Redundant)
for an explanation.
takeover command is executed after the
July 2010
write memory command at the
5-21, while synchronizing the switch
5-27.
"Where is
page 5-17