Copying The Working Directory To The Certified Directory - Alcatel-Lucent OmniSwitch AOS Release 6 Manual

Managing Redundancy in a Stack and CMM
Synchronizing the primary and secondary CMMs is done using the
described in "Synchronizing the Primary and Secondary CMMs" on page
Note. If a switch fails over to the secondary CMM, it is necessary to have a management interface connec-
tion to the secondary CMM (such as an Ethernet port or a console port).

Copying the Working Directory to the Certified Directory

Synchronizing the Primary and Secondary CMMs
At the same time that you copy the working directory to the certified directory, you can synchronize the
secondary CMM with the primary CMM. In the case of redundant CMMs, this ensures that the two
modules are booting from the same software.
To copy the working directory to the certified directory of the primary CMM and at the same time
synchronize the software of the primary and secondary CMM, use the following command:
-> copy working certified flash-synchro
Note. This command will not function if the switch is running from the certified directory. See
the Switch Running From?" on page 5-5
The copy working certified
is described in detail in the OmniSwitch CLI Reference Guide.
Note. When synchronizing the primary and secondary CMMs, it is important to remember that the
boot.params file and the switch date and time are not automatically synchronized. See the appropriate
Getting Started Guide for information on the boot.params file, and
for information on setting the switch date and time. The date and time are synchronized using the
system time-and-date synchro
page 5-26
for an explanation.
command will synchronize all switches in a stack of switches. This command
command.
OmniSwitch AOS Release 6 Switch Management Guide
Managing CMM Directory Content
copy flash-synchro command
5-27.
Chapter 1, "Managing System Files,"
"Where is
July 2010