Alcatel-Lucent OmniSwitch AOS Release 6 Manual page 176

CMM Files
Scenario 3: Synchronizing Switches in a Stack
When changes have been made to the primary CMM switch certified directory, these changes need to be
propagated to the other switches in the stack. This could be done by completely rebooting the stack.
However, a loss of switch functionality is to be avoided, a
The following diagram illustrates the process that occurs when using a copy flash-synchro command. The
stack shown is a three switch stack.
Switch #1
W
1. A copy flash-
synchro com-
mand is issued on
the primary
switch.
The copy flash-synchro command (described in
page 5-27) can be issued on its own, or in conjunction with the
(described in "Copying the Working Directory to the Certified Directory" on page
Note. It is important to certify the working directory and synchronize the stack as soon as the validity of
the software is established. Stacks booted from the working directory or unsynchronized stacks are at risk
of mismanaging data traffic due to incompatibilities in different versions of switch software. Certifying the
working directory is described in
page 5-21, while synchronizing the switch is described in
CMMs" on page 5-27.
page 5-12
Switch #2
C
W
2. The contents of
the certified direc-
tory of the primary
CMM CMM switch are
copied to the
working directory
of the secondary
CMM
The working
directory is then
copied to the certi-
fied directory.
Synchronizing Switches in a Stack
"Synchronizing the Primary and Secondary CMMs" on
"Copying the Working Directory to the Certified Directory" on
OmniSwitch AOS Release 6 Switch Management Guide
Managing CMM Directory Content
copy flash-synchro
C
3. The contents of
the certified direc-
tory of the pri-
mary CMM switch
are copied to the
working directory
of additional
switch. switches. The
working directory
is then copied to
the certified direc-
tory.
copy working certified
"Synchronizing the Primary and Secondary
command can be issued.
Switch #3
W C
command
5-26).
July 2010