Fujitsu Eternus web GUI User Manual page 517

Chapter 11 System Management
11.2 Functions in the Action Area for System
The procedure to send log is as follows:
■
Configure Automatic Log Transmission
The ETERNUS DX Disk storage system sends log periodically or when an event occurs.
Procedure
1
2
Click [Setup Log Sending Parameters] in [Action].
Specify the parameters, and click the [Set] button.
●
Send Log based on Events
• Send Log based on Events
To send logs automatically in the case of a failure, select the "Send" checkbox. The
default state of "Send Log when Errors Occur" setting is, if the Remote Support setting
using the [Setup Remote Support] function has been completed, "Send" will be
enabled.
●
Send Log Periodically
• Send Log Periodically
To send log periodically, select the "Enable Periodical Transmission of Log. " checkbox
in the "Send Log Periodically" field. The default state of "Periodic Log Periodically" is, if
the Remote Support setting using the [Setup Remote Support] function has been
completed, "Enable Periodical Transmission of Log. " will be enabled.
• Time
Specify between "0:00" and "23:59" for the time to send logs periodically. A time
between "10:00" and "15:00" is set for the default setting. (*1)
• Cycle
Specify the cycle when sending logs periodically.
- Once per Week
- Every Day
• Day of the Week
Specify the day of the week when sending logs periodically. The day of the week can
be specified only when "Once per week" has been specified as the cycle when sending
logs periodically. A day between "Monday" and "Friday" is set for the default setting.
(*1)
- Sunday
- Monday
- Tuesday
- Wednesday
- Thursday
- Friday
- Saturday
*1: Different days and times are specified in the factory settings in order to disperse the load on
the REMCS center.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
517
P2X0-1090-02ENZ0