Table of Contents
Advertisement
Chapter 11 System Management
11.2 Functions in the Action Area for System
The procedure to set the SNMP Agent community is as follows:
Procedure
1
2
3
The SNMP Agent Managers which are allowed to access, and the MIB
access range, can be specified for each community.
Click [Setup SNMP Community] in [Action].
Click the [Add] button.
Click the [Community Name] link to edit the existing community
information.
Input or edit the community, and click the [OK] button.
•
Community Name
Enter the community name to be used when accessing a MIB or sending a trap.
The community name which has already been used cannot be entered.
The following input conditions apply:
-
1 - 32 alphanumeric characters and symbols
-
"! (exclamation mark)", "# (hash mark)", "& (ampersand)", "_ (underscore)", "+
(plus)", "- (hyphen)", "* (asterisk)" and "/ (slash)" can be used
-
Spaces
•
MIB View
Select the view name to specify the MIB access range for the community.
A "blank" means accessing the MIB is not allowed.
•
Allowed SNMP Manager List
Select the IP address of the SNMP Agent Manager which is allowed to access in the
community.
Only the selected SNMP Agent Manager is allowed to access.
However, if the Allowed SNMP Agent Manager List has been left blank, all of the SNMP
Agent Managers (*1) are allowed to access.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
475
P2X0-1090-02ENZ0
Advertisement
Table of Contents
