Table of Contents
Advertisement
Chapter 8 Advanced Copy Management
8.2 Functions in the Action Area for Advanced Copy
The procedure to modify the EC/OPC priority is as follows:
Procedure
1
2
Registering the license for the Advanced Copy feature is required to use
EC and OPC.
•
EC includes both EC and REC.
The REC priority that is specified using the procedure in
REC Multiplicity" (page 246)
EC/OPC priority values are used for REC priority when the connection
method is "Direct".
Refer to
Refer to
settings.
•
OPC includes OPC, QuickOPC, SnapOPC, and SnapOPC+.
Click [Modify EC/OPC Priority] in [Action].
Select the EC/OPC priority, and click the [Modify] button.
•
EC/OPC Priority
-
Automatic Priority
This mode changes the EC/OPC priority automatically in response to the operating
load status.
-
High Priority
This mode operates by making maximum use of internal resources.
This mode greatly affects host access performance, thus should not be used during
normal operation. Use when the operation load is low.
-
Low Priority
This is a mode in which the influence on host access is reduced to a minimum.
Select this mode when using EC and/or OPC during operation.
→ A confirmation screen appears.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
is normally used. Note that the specified
"8.2.8 Set Copy Path" (page 217)
"8.2.14 Modify REC Multiplicity" (page 246)
206
"8.2.14 Modify
for connection type settings.
for REC multiplicity
P2X0-1090-02ENZ0
Advertisement
Table of Contents
