Table of Contents
Advertisement
Chapter 3 Initial Setup
3.2 Initial Setup 2
3.2
Initial Setup 2
This sets the various reports that are generated when an error occurs in the ETERNUS DX Disk
storage system.
If monitoring the ETERNUS DX Disk storage system, use this wizard to build an environment.
The flow of wizard operations in Initial Setup 2 is shown below.
(1) Set SNMP Agent Basic
Set up the SNMP Agent basic interface in the ETERNUS DX Disk storage system. Refer to
"11.2.3.3 Setup SNMP Agent Basic Interface" (page 464)
(2) Set SNMP Manager
Specify the IP address of the SNMP Agent Manager. Refer to
Manager" (page 466)
(3) Set SNMP Agent MIB View
Set the MIB View of the SNMP Agent. Refer to
View" (page 468)
(4) Set SNMP Agent User
Set up the user which accesses the SNMP Agent.
The security level and the MIB access range are configured for each user. Refer to
Setup SNMP Agent User" (page 471)
(5) Set SNMP Agent Community
Set up the SNMP Agent Community. Refer to
(page 474)
(6) Set SNMP Agent Trap
Set up the environment to send notification of events that occur in the ETERNUS DX Disk
storage system to the SNMP Agent Manager by an SNMP Trap. Refer to
SNMP Agent Trap" (page 477)
(7) Set E-Mail Notification
Set the E-mail notification for events that occur in the ETERNUS DX Disk storage system.
Refer to
(8) Set Syslog Notification
Set up external servers (Syslog server) for sending logs of events that are detected by the
ETERNUS DX Disk storage system. Refer to
for details.
for details.
for details.
for details.
"11.2.3.12 Setup E-Mail Notification" (page 484)
42
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
for details.
"11.2.3.4 Setup SNMP Agent
"11.2.3.5 Setup SNMP Agent MIB Access
for details.
"11.2.3.7 Setup SNMP Agent Community"
for details.
"11.2.3.13 Setup Syslog" (page 487)
"11.2.3.6
"11.2.3.8 Setup
for details.
P2X0-1090-02ENZ0
Advertisement
Table of Contents
