Fujitsu Eternus web GUI User Manual page 465

Chapter 11 System Management
11.2 Functions in the Action Area for System
Procedure
1
2
Click [Setup SNMP Interface] in [Action].
Specify the parameters, and click the [Set] button.
• SNMP Function
Select whether to enable or disable the SNMP function.
• LAN Port used for SNMP
When enabling the SNMP function, select the port used for SNMP from "MNT" or
"RMT".
When sending a SNMPv1 trap, the agent-address of the trap sender is the Master CM
IP address of the selected port.
• Authentication Failure
When enabling the SNMP function, select "Send SNMP Trap" or "Do not send SNMP
Trap" when authentication fails.
• Engine ID
When enabling the SNMP function, enter the engine ID of the SNMP.
The engine ID is a unique identifier used to distinguish the connection target device
between the SNMP Agent Manager and the SNMP Agent.
Normally, the default value is used. The default engine ID of the ETERNUS DX Disk
storage system is as follows:
Octet 1 - 4: Bitwise OR between the company code (fujitsu=211) and 0x80000000
Octet 5: 0x80 (fixed)
Octet 6 - 13: WWN of the ETERNUS DX Disk storage system (8 bytes)
The following input conditions apply:
- Alphanumeric characters (0 - 9, A - F, a - f)
- Inputting only "0" or "F" for the "Engine ID" field is not allowed
- 10 - 64 characters (even number)
→ A confirmation screen appears.
If the entered engine ID does not satisfy the input conditions, an error
screen appears.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
465
P2X0-1090-02ENZ0