Table of Contents
Advertisement
Chapter 11 System Management
11.2 Functions in the Action Area for System
3
4
11.2.4.5
Setup Log Sending Parameters
This function transfers the internal log of the ETERNUS DX Disk storage system to the REMCS
center.
There are two log sending methods: "Automatic" and "Manual".
•
Configure Automatic Log Transmission
The ETERNUS DX Disk storage system sends log periodically or when an event occurs.
•
Immediately Send Log Manually
Send log manually.
Click the [OK] button.
→ Changing of the communication environment information starts.
Click the [Done] button to return to the [Remote Support] screen.
After completing the setting, the REMCS center sends the setting
confirmation result to the "Administrator E-Mail Address" or the "E-
Mail address result notification". Make sure to confirm the setting
results.
This function cannot be used under the following conditions:
•
When the procedure in
not performed.
•
When a problem is detected in the Remote Support settings
•
When the "Receiver Mail Address" (REMCS center) is not specified for
the Remote Support
•
The Remote Support is stopped
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
"11.2.4.2 Setup Remote Support" (page 502)
516
End of procedure
is
P2X0-1090-02ENZ0
Advertisement
Table of Contents
