Table of Contents
Advertisement
Chapter 11 System Management
11.2 Functions in the Action Area for System
3
4
11.2.3.3
Setup SNMP Agent Basic Interface
This function sets up the SNMP Agent basic interface in the ETERNUS DX Disk storage system.
SNMP is a standard protocol used for network management.
The procedure to set the basic information of SNMP Agent is as follows:
Click the [OK] button.
→ Setting of the firewall starts.
Click the [Done] button to return to the [Network] screen.
•
When SNMP Agent Manager exists in a different subnetwork from
where the ETERNUS DX Disk storage system belongs, specify the IP
address or the network address of SNMP Agent Manager in the
"Allowed IP List" using the procedure in
Environment" (page
•
Before enabling the SNMP function, use the procedure in
Setup Firewall" (page 462)
setting target LAN port.
•
When using the procedure in
SNMP Agent environment can be configured by the wizard. When the
[Initial Setup] function is not used, configure the SNMP Agent
environment in the following order:
(1)
Setup SNMP Agent Basic Interface
(2)
Setup SNMP Agent Manager
(3)
Setup SNMP Agent MIB Access View
(4)
Setup SNMP Agent User
(5)
Setup SNMP Agent Community
(6)
Setup SNMP Agent Trap
•
The parameter settings specified using this function remain even when
the "SNMP Function" setting is changed from "Enable" to "Disable".
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
458).
to allow the "SNMP" connection for the
"Chapter 3 Initial Setup" (page
464
End of procedure
"11.2.3.1 Setup Network
"11.2.3.2
31), the
P2X0-1090-02ENZ0
Advertisement
Table of Contents
