E2 Hardware Setup; Setting Up The E2; Enclosure; Main Processor Board - Emerson E2 Installation And Operation Manual

4

E2 Hardware Setup

4.1

Setting up the E2

4.1.1

Enclosure

Figure 4-1
- E2 Inside Enclosure
Open the door and expose the main processor board.
The main processor board and power interface board (PIB)
are mounted side by side, one on each side of the box
enclosure.
Note that the door of the E2 controller is not compati-
ble with the previous E2 version. The enclosure doors are
not interchangeable.
Setting up the E2
4.1.2

Main Processor Board

Figure 4-2
- E2 Main Board
The main processor board is mounted on the hinged
door part of the enclosure, directly behind the keyboard.
NOTE: E2 enclosure doors are not backwards com-
patible between E2 units version 3.xx and below and
units that are version 4.0 and above. Keep each unit's
door with its correct case.
• -
E2 Hardware Setup 4 1