Emerson E2 Installation And Operation Manual page 232

Alarm Name
External Fault
Failed Attempt To Bind Input
Failed Sensor Or Bad Wiring
Failed To Create logging
Failed to Obtain DHCP Lease
Failed to Renew DHCP Lease
Fax Init String Is Not Valid
Features denied during restore
Features denied during startup
File Not Found
Firmware File Bad - AI200
Firmware File Bad - RO200
Firmware File Bad - CC100 Liq
Firmware File Bad - CC100 Suct
Firmware File Bad - CS100 Ckt
Firmware File Bad - ESR8
Firmware File Bad - RT100
•
C-6 E2 RX/BX/CX I&O Manual
Default
Priority
30 An external fault input defined in a Multiflex PAK
controller has indicated a failure. External fault
inputs in the PAK are used to detect a Rack (Pack)
failure produced by some device out of the PAK's
control.
50 A valid link could not be made between an E2 appli-
cation and an input assigned to it.
20 E2 is unable to get a valid sensor value due to a possi-
ble hardware problem.
20 E2 is unable to create logs for the input or output
shown.
20 Failed to obtain a DHCP lease from the DHCP
Server, when a lease is requested. This happens at
system startup, if a DHCP lease is requested, or if the
user switches to using DHCP.
20 DHCP Lease failed to renew altogether. DHCP
Leases are renewed at an interval of half the time of
the requested lease. If the lease is for 5 days, then a
renewal will happen at 2.5 days. If this fails, it will
retry at the ¾ of the lease time. If both attempts fail,
the alarm is generated.
30 The fax initialization string for the E2's modem is
incorrect and may need editing.
99 License manager has denied permission to access a
feature during a restore. Either the license for that
feature is invalid or it does not exist, or the number of
licenses for that feature is less than the number
needed for the configuration. Further information
may be found in the service log.
99 License manager denied permission to access a fea-
ture during startup. Either the license for that feature
is invalid or it does not exist, or the number of
licenses for that feature is less than the number
needed for the configuration. Further information
may be found in the service log.
50 An internal error has occurred in the E2.
15 A 16AIe has corrupted firmware.
15 An 8ROe has corrupted firmware.
15 A CC-100P or CC-100LS has corrupted firmware.
15 A CC-100H has corrupted firmware.
15 A CS-100 has corrupted firmware.
15 An ESR8 has corrupted firmware.
15 An RT-100 has corrupted firmware.
Definition
026-1614 Rev 4 5-JAN-2013