Emerson E2 Installation And Operation Manual page 233

Alarm Name
Firmware Is Not Compatible
Firmware Update Failed
Flash File Has A Bad CRC Error
Flow obstructed
Fuse Is Blown - ESR8
Global Spare Dig1 On
Gradual Change Limit Exceeded
Heap Memory Corrupted - Reboot 30
High Discharge Limit Exceeded
High Limit Alarm
High Limit Notice
High Suction Limit Exceeded
HVAC Phase Loss
HVAC Shutdown
Incomplete Advisory Setup
Inhibit Sensor Failed
Input Bypass Failure
Input Sensor Is Open
Input Sensor Is Short
Instance limit exceeded
Invalid Cell ID In Scratch Pad
Invalid Nxt Ptr In Scratch Pad
Invalid Scratch Pad Block Size
Default
Priority
20 The firmware in a unit controller is not compatible
with the current version of E2.
10 The firmware on a unit controller was not success-
fully updated.
50 An internal error has occurred in the E2.
30 Irrigation pipe obstruction detected.
20 A fuse has blown on an ESR8 board and will require
replacement.
User The Spare Dig 1 input in Global Data has switched
ON.
User An analog value has undergone a gradual change
greater than its programmed Minimum Change set-
point.
A problem with memory has resulted in a reset of the
E2.
User A high discharge pressure detected by a Suction
Group application is causing the suction group to
operate at a reduced capacity.
User An HVAC application (AHU, Zone, RT-100, or
ARTC/MultiFlex RTU) has a temperature above one
of its cooling setpoints.
50 Network variable high limit exceeded.
User The suction pressure has risen above a Suction
Group's high suction setpoint.
User A phase loss device connected to Global Data has
switched ON to shut down all HVAC systems.
User A Global Data application's HVAC Shutdown input
has turned ON to shut down all HVAC systems.
15, 99 An important setting used in advisory and/or dial-out
set up were not configured correctly.
User A Demand Defrost Inhibit sensor on a case circuit is
not functioning correctly.
15 A command to bypass an input was not successfully
carried out.
20 An analog input sensor is OPEN, possibly due to a
severed connection or sensor failure.
20 An analog input sensor is CLOSED, possibly due to a
short-circuit or sensor failure.
20 Maximum number of a particular type of licensed
Open Echelon controllers has been reached. A new
instance cannot be commissioned.
30 An internal error has occurred in the E2.
30 An internal error has occurred in the E2.
30 An internal error has occurred in the E2.
Definition
Appendix C: Alarm Advisory Messages
• -
C 7