E2 Hardware Setup; Setting Up The E2; Enclosure; Main Processor Board - Emerson E2 Installation And Operation Manual

4

E2 Hardware Setup

4.1

Setting up the E2

4.1.1

Enclosure

Figure 4-1
- E2 Inside Enclosure
Open the door and expose the main processor board.
The main processor board and power interface board (PIB)
are mounted side by side, one on each side of the box
enclosure.
Setting up the E2
4.1.2

Main Processor Board

13
12
1
LCD Connector
2 Echelon Plug-In
3 Power Interface Board Connector
TCP/IP Ethernet Connector
4
5 External Keyboard Connector
6 Lithium Battery
Battery Enable Switch
7
Figure 4-2
- E2 Main Board (RX-100 Board Shown)
The main processor board is mounted on the hinged
door part of the enclosure, directly behind the keyboard.
14
8 Reset and Clean Out Buttons
9 Test Button
10 General Status LED
11 Backlight Inverter
Contrast Adjust (E2 100 Ver. Only)
12
13 Backlight Dim Adjust (E2 100 Ver. Only)
14
Boot Status LED
E2 Hardware Setup
• -
4 1