Emerson E2 Installation And Operation Manual page 239

Alarm Name
RX/BX Firmware Update Failed
RX/BX Firmware Was Updated
Smoke Detected
SRAM Memory Corrupted -
Reboot
State Switched 'On'
Status Config Loss-CRC Error
Stuck
System date needs manual reset
System In Pump Down
Template File Bad - CC100 Liq
Template File Bad - CC100 Suct
Template File Bad - CS100 Ckt
Test Dial Successful
Time Updated By A User
Time Updated Over Network
Timed Out Waiting For FW Updt. 50
Too Many Reboots: Flash erased
Too Many Reboots: SRAM erased 50
Total On Time Exceeded Limit
Trip Alarm
Tripped
Unit Ctlr Cell Create Failed
Unknown FW Update Attempted
Unknown Heap Operation Error
Unoccupied Hi Limit Exceeded
Unoccupied Low Limit Exceeded
Default
Priority
20 The E2's firmware update was not successful.
50 The E2's firmware was successfully updated.
30 A smoke detector input on an ARTC/MultiFlex RTU
has detected smoke.
30 A problem with memory has resulted in a reset of the
E2.
User A digital value that has been set up to alarm when
ON has switched ON.
30 An internal error has occurred in the E2.
30 MultiFlex ESR controller has detected a stuck valve.
20 The date/time of the box is not valid.
User The suction pressure has fallen below the pump down
setpoint for a Suction Group, causing shutdown of
the rack.
15 A template file in E2 for a CC-100P or CC-100LS is
bad.
15 A template file in E2 for a CC-100H is bad.
15 A template file in E2 for a CS-100 is bad.
50 E2 performed a test dial-out with its modem, and the
dial-out was successful.
99 A user changed the time in the current E2.
99 The time in the current E2 was updated by another
controller or user on the network.
The E2 waited for a firmware update to begin, and it
never did.
50 A number of successive reboots has erased the Flash
RAM.
A number of successive reboots has erased the
SRAM.
User A digital value's total ON time has exceeded its
defined Time ON Total setpoint.
30 Generic pulse trip alarm.
20 WPK condenser fan or compressor trip.
20 The E2 unsuccessfully tried to create a unit controller
cell.
50 An error has occurred during a firmware update of
E2. Call Emerson Retail Solutions service for assis-
tance.
50 There is an internal error in the E2 software. Notify
Emerson Retail Solutions service.
User An analog value has risen above its defined high limit
setpoint during UNOCCUPIED mode.
User An analog value has fallen below its defined low
limit setpoint during UNOCCUPIED mode.
Definition
Appendix C: Alarm Advisory Messages
• -
C 13