Dynamic Range; Sp Delay - Yamaha RX-Z1 Owner's Manual

!
Use this feature to adjust the dynamic range. This setting is effective only when this unit decodes Dolby Digital signals.
Choices: MAX, STD, MIN
Initial
setting:
MAX (tier both speakers and headphones)
i", r'_LiMt"ii',iTi " pi'i},h:_;
.L,. i.Iii_ihLl., ' ¢',I"M=._L,
÷ :.:.;F:': i,-!'!!:!X '2-;TC' M! H
_5
_3
MA)_
Dialog _ STDMIN
MIN_
STD J/
VlAX "
MAX: Select the "MAX" setting for feature films.
STD: Select the "STD" (Standard) setting for general use.
MIN: Select the "MIN" setting for listening to sources at
extremely low volume levels.
Input level
• Some types of the Dolby Digital software do not support "MIN" for the dynamic range.
If "MIN" is selected to play this type of software, the volume may be extremely
lowered. If this problem occurs, select "MAX" or "STD".
Use this feature to adjust the delay of the center and the rear center channel sounds. This feature works when there is sound output from the
center speakers, with a source like Dolby Digital or DTS, etc.
\\
i':r ,:_pP_i::i i:i_,,, _
÷ U!!!T, ...... _>eet
_'!!:!!!'!!../R, !0: 0£t
CENTE!;_,, =1.0:0_t
REaR!../R, !@,0f't,
REaRCT,,, 7: _i)_"!,
Center speaker image
r-I!
/ \ I / \
// \ I / \
\ / \
\ I / \
\ I / \
\\ I //
/ I \, ,'
",/ix,"
,FIG,
- - ;- -_
Rear center speaker image
Ideally, the center speaker and the rear center speaker should be the same distance from
the main listening position as the left and right main speakers. However, in most home
situations, the center speaker or the rear center speaker is placed in line with the main
speakers or the rear speakers. By delaying the sound from the center speaker and the rear
center speaker, the apparent distance from the center speaker and the rear center speaker
to the main listening position can be adjusted to make it seem the same as the distance
between the left and right main speaker, and the left and right rear speakers to the listening
position. Adjusting the delay time tk_r the center speaker is especially important tk_r giving
depth to the dialogue.
Tap @ or _ to select "UNIT".
FN
Tap _ or _ to select the unit to be used for setting.
Select one from "msec", "meters", and "feet".
° Setting items change depending on the unit chosen.
° When "meters" or "feet" is selected, enter the distance from your listening position
to each speaker.
@ or _ to select the for which the is
Tap
speaker delay adjusted.
Tap _ or @ to set the delay.
Tap _ for higher value and _ tk_r lower value.
E-66