Selecting A Sound Field Program - Yamaha RX-Z1 Owner's Manual

You can enhance your listening experience by selecting a DSP program. There are 12 programs with sub-programs available with this unit.
However the selection depends on the input signal format and not all the sub-programs are possible for all input signal formats. For details
about each program, see pages to
_Tap
on the RECEIVER control panel to open
the DSP control panel.
The DSP control panel is displayed as shown below.
• The whole DSP control panel consists of three control panels
(pages 3/8 to 5/8). You can scroll through these control panels
using _ and _. The controls also can be
used to select one of three DSP control panels.
After selecting the desired program, tap the same button
repeatedly to select the desired sub-program if available.
•
Example:
Each time or _ is tapped the sub-
programs ("Spectacle" and "Sci-Fi") switch.
_BLE *,_D_APE dis i'.4 i"*=i i T i...... i" i i r" i"*="i" r" r"= .i
..... i'i U ',,,=,i, i::" i i"i i::" i"_ i i::" r=:. ,i.
vcR1 TU_ER
_o°o
155N77
i,2 i 2) 2) i"" i::_L, L, ,::i L, ,i. i::_ _y
Q
v Au×
_ Select the desired
program.
<On the front panel>
Press PROGRAM El>.
_== PROGRAM I_
<On the remote control>
Tap one of the DSP program buttons (such as or
• If a Dolby Digital or DTS signal is input when the input mode
is set to "AUTO", the DSP program automatically switches to
the appropriate decoding program.
• Choose a DSP program based on your listening preference,
and not on the name of the program. The acoustics of your
listening room affect the DSP program. Minimize the sound
reflections in your room to maximize the effect created by the
program.
• When you select an input source, this unit automatically
selects the last DSP program used with that source.
• When you set this unit in the standby mode, the current
source and DSP program are memorized and are automati-
cally selected when you turn on the power again.
• When a source connected to the 6CH INPUT jacks of this
unit is selected, the digital sound field processor cannot be
used.
• While the over 96 kHz sampling digital signals are being
input, sound effects cannot be added and only normal stereo
playback is possible.
• Sound effects will be added to 96 kHz sampling digital
signals after converted to 48 kHz.
E-48