Input Modes And Indications; Notes On The Digital Signal - Yamaha RX-Z1 Owner's Manual

:_"][_ Id It,-\2:Y,-Te._
This unit comes with various input jacks. If your external compo-
nent is connected to more than one type of input jack, you can set
the priority of the input signal. Press INPUT MODE on the front
panel or tap an input selector button (tap it repeatedly) on the
remote control to display or change the input mode.
INPUT MODE
%
D CABLE SAT VCR1
®®@
VCR2 VCR3tDVR ICU MDIT_IPE TUNER
@@@@®
CD-R PHONO V-AUX 6OH ZONE2
• Notes on the digital signal
The digital input jacks of this unit can handle up to 192 kHz
sampling digital signal. Both OPTICAL and COAXIAL input jacks
can be used to input the digital signal up to 96 kHz. However when
inputting the higher digital signals than 96 kHz, be aware the
following points.
• DSP programs cannot be selected. Sound will be output as normal
2-channel stereo sound from only the left and right main speakers.
• Use the coaxial input (COAXIAL IN)jack to input over 96 kHz
digital signal. The signals may not be correctly played back if the
optical input (OPTICAL IN)jack is used.
• Level adjustment for effect speakers excluding a subwoofer is not
possible.
Sound effects will be added to 96 kHz sampling digital signals after
converted to 48 kHz.
.i. r ir"u i i......... i.... ;;_,;,,_i
, i"iLJ i LJ, i...= i .:::,_
Input mode
AUTO: This mode is automatically selected when you turn on the
power of this unit. In this mode, the input signal is automatically
selected in the following order.
@ Digital signals
@ Analog signals
<When D-TWLD is selected as the input source>
@ Dolby Digital RF encoded signals
@ Digital signals
@ Analog signals
D.D. RF: This unit only selects Dolby Digital RF signals (when D-
TV/LD is selected as the input source).
DTS: In this mode, only digital input signals encoded with DTS are
selected even if other signals are input at the same time.
DGTL: This unit only selects digital signals input through the
OPTICAL or COAXIAL jacks (when D-TV/LD is selected as the
input source).
ANALOG: In this mode, only analog input signals are selected
even if digital signals are input at the same time.
• When you turn on the power of this unit, the input mode is set
according to "9 INPUT MODE" on the SET MENU (see page __
for details).
• When you connect components to both the COAXIAL and
OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack.
E-46