Connecting A Front Subwoofer; Connecting A Rear Subwoofer; Impedance Selector Switch - Yamaha RX-Z1 Owner's Manual

Subwoofer system
Right
.................. F-®:: ®
Su bwoofer system
Su bwoofer system
Left
Right rear speaker Left rear speaker
)__ REAR C
Subwoofer system
WARNING
Do not change the IMPEDANCE SELECTOR switch setting
while the power to this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FALLS TO TURN ON WHEN THE STANDBY/
ON SWITCH IS PRESSED:
The IMPEDANCE SELECTOR switch may not be set to either
end. If so, set the switch to either end when this unit is in the
standby mode.
• Connecting a front subwoofer
Connect the signal input jack on your subwoofer to the PREOUT/
MAIN IN SUBWOOFER MONO jack.
By connecting two subwoofers to the SUBWOOFER SPLIT jacks,
this unit can reproduce subtle directional changes in the low
frequency sounds.
When you use two subwoofers, connect both of them to the
SUBWOOFER SPLIT jacks using pin plugs.
• Connecting a rear subwoofer
By using both front and rear subwoofers, the CINEMA-DSP sound
field programs can produce realistic movie effects with powerful,
dynamic sound. To take advantage of this dynamic sound, be sure to
set the "IC REAR L/R SP" item in the SET MENU to "LARGE"
(see page __).
• Adjust the speaker volume tk)r the subwoofer with the controls on
the subwoofers, not on this unit.
• Impedance selector switch
Select the position whose requirements your speaker system meets.
_ (Upper position)
Front effect: The impedance of each speaker must be 6__ or
higher.
Rear: The impedance of each speaker must be 4__ or
higher.
Rear Center: The impedance of the speaker must be 4__ or higher.
Center: The impedance of the speaker must be 4__ or higher.
Main: If you use one pair of main speakers, the impedance
of each speaker must be 4__ or higher. If you use
two pairs of main speakers, the impedance of each
speaker must be 8__ or higher.
_ (Lower position)
Front effect: The impedance of each speaker must be 8__ or
higher.
Rear: The impedance of each speaker must be 8__ or
higher.
Rear Center: The impedance of the speaker must be 8__ or higher.
Center: The impedance of the speaker must be 8__ or higher.
Main: If you use one pair of main speakers, the impedance
of each speaker must be 8__ or higher. If you use
two pairs of main speakers, the impedance of each
speaker must be 16__ or higher.
E-30